Drive Motor; Removing Dipstick; Bottom Of Drive Motor - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 15 Service Manual
Electrical Components

Drive Motor

Figure 7-53.

Removing Dipstick

Removal
1. Remove tractor covers. See "Tractor
Covers" on page 7- 1 1.
2. Turn drive unit using steering wheel so
you can reach power cables.
Turn key switch OFF and disconnect
3.
4. Remove brake from drive motor (if the
motor is to be replaced). See "Brake" on
page 7-27.
5. Disconnect power cables from drive motor.
Note location for installation and label if
necessary.
Remove steer motor. See "Steer Motor" on
6.
page 7-42.
7. Remove dipstick and plug. See
Figure 7-53.
8. Remove the bracket that activates the
home prox switch.
00700-CL222-05, 1 5 March 2005
Section 7. Component Procedures
9. Break seal between drive motor flange and
drive unit. Use 2 screws from steer motor
mounting plate. See Figure 7-54.
Breaking Seal Between Motor and Drive Unit
Figure 7-54.
10. Attach a suitable hoist to drive motor and
lift motor out of truck.
Clean sealant from motor flange and cap
11.
screws for drive motor. See Figure 7-55.
Figure 7 -5 5 .
Drive Motor