Toyota Orderpicker Model 7BPUE 15 Service Manual
Install Kit Components
Before installing kit components, turn the key
switch OFF, disconnect the battery and remove
the appropriate covers.
N
: Once you install all the components,
O TE
complete the Set-Up Procedure
beginning on 8-9.
Guidance Manager (Steer
Controller Card and Filter Card)
The guidance manager is a n assembly
comprised mainly of a steer controller card and
a filter card. The wire guidance firmware is
housed in the WSI module.
1. Wear a static strap and insert the WSI
module (P/N 00590-458 18-7 1) into the
socket on the steer controller card. See
Figure 8- 1.
8- 1 .
Figure
Steer Controller Card
2. Install the steer controller card assembly
panel with four hex spacers (P/N
00590-02988-7 1). See Figure 8-2.
3. Install the filter card assembly (P/N
00590-45747-71) on the steer controller
card. Secure with four screws (P/N
00590-45925-7 1) in the hex spacers. See
Figure 8-2.
00700-CL222-05, 1 5 March 2005
Figure
Guidance Manager, Installed
4. Install the power and ground cable (P/N
00590-4588 1-71) to connector PS2 on the
steer controller card. Route the wires
through the wiring channel along the
shown on the schematic. (See Figure A-6
on page A- 13.) Use cable ties a s necessary.
5. Install the CAN bus wiring harness (P/N
00590-45881-71) to PS4 on the steer
controller card. Route the harness along
the existing wiring to the steer/tractor
manager connector PT2. Use cable ties a s
necessary.
Figure
Load Sensor Assembly, Installed
Section 8. Wire Guidance
Install Kit Components