Jacking Safety; Tractor; Operator Platform - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE15 Service Manual

Jacking Safety

Sometimes you may need to jack the truck up
from the floor to perform maintenance
procedures. When doing so, observe the proper
safety precautions:
1. Lower the forks completely. Remove any
load.
2. Place all controls in neutral.
3. Block the wheels to prevent movement of
the vehicle.
4. Disconnect the battery connector.
5. Place the jack under the designated
jacking points listed in the following
procedures.
Use extreme care whenever the truck
jacked up. Keep hands and feet clear
from the vehicle while jacking the truck.
After the truck is
blocks beneath it to support it. DO NOT
rely on the jack alone to support the
truck.

Operator Platform

Using the lift button, raise the operator
1.
platform until you have enough clearance
for your procedure.
2. Place a safety stand or block between the
carriage and a baseleg and carefully lower
the operator platform onto the safety
stand.
3. Turn the key switch OFF and disconnect
the battery.
00700-CL222-05, 1 5 March 2005
jacked, place solid

Tractor

Use care when jacking the tractor on
wire-guided trucks. Sensors are
installed under the bumper. See
2-4.
Figure
is
Only jack in these areas,
no more than
( 1 3mm) off the floor.
Figure Tractor Jacking Points
1. Place the jack a t the designated jacking
point. See Figure 2-4.
2. Jack one side of the truck so that the drive
tire is off the floor approximately
(25.4 mm).
3. Block that side of the truck in place.
4. Jack u p the other side of the truck level
with the first side.
5. Block that side of the truck in place.
N : After working on a vehicle, test all
O TE
controls and functions to assure proper
operation.
Section 2. Safety
Jacking Safety
1 /2
in.
inch
1