Two-Stage Carriage; Finger Guard - Toyota 7BPUE15 Service Manual

Section 7. Component Procedures

Two-Stage Carriage

T -Stage Carriage
WO
Use extreme care whenever the truck is
jacked up. Never block the truck
between the mast and the floor. Keep
hands and feet clear from vehicle while
jacking the truck. After the truck is
jacked, place solid blocks beneath it to
support it. D O NOT rely on the jack
alone to support the truck. S e e "Jacking
2- 1 1.
Safety" on page
Removal
1. Turn key switch OFF and disconnect
battery.
2. Remove operator console cover. See
"Operator Console Cover" on page 7-12.
3. Remove front carriage plate (below
console).
4. Disconnect JPC8 and JPC9 from carriage
manager and cut cable tie from tractor
side.
5.
Feed electrical over -the-mast cable
through cable raceway.
Do not place hands between the masts
before blocking the carriage.
6. Feed cable through carriage to tractor.
on chains. Block carriage.
Toyota Orderpicker Model 7BPUE 15 Service Manual
8. Remove finger guard. See Figure 7- 130.
Figure 7- 130. Finger Guard
9. Disconnect inside chain anchors a t the
bottom of the carriage. See Figure 7- 131.
Figure 7- 13 1. Inside Chain Anchor, View From Operator
Platform
10. Place disconnected end of chains over the
top of the mast, toward tractor. See
Figure 7- 132.
00700-CL222-05, 1 5 March 2005
Mast Section