Toyota Orderpicker Model 7BPUE 15 Service Manual
Mast Section
1. Line up bottom roller bearings in the outer
mast channel and lower into main frame.
See Figure 7- 124.
Install upper roller bearings on the outer
mast.
Remove block from outer mast and lower
both masts.
Install bolt in the top of each piston. See
Figure 7- 125.
00700-CL222-05, 1 5 March 2005
Section 7. Component Procedures
5. Apply adhesive (P/N 00590-04964-7 1) to
bolts and install chain pulleys. See
Figure 7- 125.
7-
Figure
125. Attaching C
y
6. Install chains and secure in chain
anchors. See Figure 7- 126.
7- 126.
Figure
lower Chain Anchor Block
7. Install center cylinder. See "Center
Cylinder" on page 7-69.
8. Install over-the-mast hose and cable
pulleys to outer mast.
9. Install hoist on outer mast and lift until
inner mast raises enough to expose cable
bracket.
Inner Mast
linder a n d lnner mast