Lnner Mast; Bottom Chain Anchor Block - Toyota 7BPUE15 Service Manual

Section 7. Component Procedures
Inner Mast

lnner Mast

Use extreme care whenever the truck is
jacked up. Never block the truck
between the mast and the floor. Keep
hands and feet clear from vehicle while
jacking the truck. After the truck is
jacked, place solid blocks beneath it to
support it. D O NOT rely on the jack
alone to support the truck. S e e "Jacking
2- 1 1.
Safety" on page
Removal
1. Remove platform. See "Three-Stage
Carriage" on page 7-74.
2. Attach hoist to inner mast and lift 2-3
chain.
3. Disconnect chains from bottom chain
anchor block of each side cylinder. Swing
chains over each pulley. See Figure 7- 12 1.
7- 12
Figure

1. Bottom Chain Anchor Block

4. Remove each chain pulley. See
Figure 7- 122.
Toyota Orderpicker Model 7BPUE 15 Service Manual
7-
Figure 1 2 2 . lnner mast, Chain Pulley Removed
5. Remove center cylinder. See "Center
Cylinder" on page 7-69.
one side of inner mast.
7-
Figure 123. Over-the-Mast Cable a n d H
7. Remove over-the-mast cable and pulley
from other side of inner mast. Note
location of cable ties. See Figure 7- 123.
8. Raise inner and outer mast 1 ft.
(0.3 m) off floor. Block outer mast.
9. Remove flathead screws and upper roller
bearings on outer mast.
10. Use a hoist to the remove inner mast.
00700-CL222-05, 1 5 March 2005
Mast Section
mast
y draulic Hose