Center Cylinder Ride Spring Chain Anchors - Toyota 7BPUE15 Service Manual

Section 7. Component Procedures
Three-Stage Carriage
9. Tie electric cables to platform. See
Figure 7- 1 16.
7-
1
Figure 16. Tie Points for Cables on Platform, Backside
10. Install carriage stops a t top of inner mast.
See Figure 7- 1 17.
7- 1
Figure 17. Inner mast, Top Corner
1 1. Lower carriage and install cable on bottom
pulley of carriage. Install cable retainer
spring. See Figure 7- 1 18.
7- 1
Figure 18. Electrical Over-the-Mast Cable, Front Side of
Platform
Toyota Orderpicker Model 7BPUE 15 Service Manual
N : There are 6 in.(152 mm) from the top of
O TE
the spring on the carriage to the center
bolt in the cable clam^.
12. Install carriage plate.
13. Install mast guard.
14. Lift and lower platform fully, and check
functions of lift system. Look for:
Oil leaks
Cables on pulleys
Switch actuation
Unusual bearing noise
Center Cylinder Ride Spring
Chain Anchors
Inspection of the chain anchors and pivot
3. Place blocking under the operator's
platform. Lower the platform onto the
support.
4. Disconnect the battery connector and
open the emergency lower valve.
The center cylinder will move down and
the chains will go slack. If the center
cylinder does not go down far enough to
slacken the chains, push down on the
of the cylinder. This will allow the chain
anchor to be visible for inspection. See
Figure 1 19.
7-
00700-CL222-05, 1 5 March 2005
Mast Section