Pallet Clamp; Pallet Clamp Assembly, Underside - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 15 Service Manual
Mast Section

Pallet Clamp

7- 145.
Figure

Pallet Clamp Assembly, Underside

Install
1. Install the pallet clamp assembly on the
platform front plate. Secure it with four (4)
.
Nm)
2. Install the pedal assembly to the platform
main support plate. Secure it with two (2)
(20 Nm).
3. Hook the tension spring into the 1/4-inch
holes in the pivot bracket and pedal weld
in the pedal assembly. See Figure 7-145.
4. To extend the spring so you can connect
the cable assembly, slide a 2-inch-wide
block between the left hand pallet support
and the pallet clamp on the pallet clamp
assembly.
5. Install the cable bracket on the pedal
assembly. Secure it with the M8 X 10
shoulder bolt and M8 hex nut. Torque to
15 ft. lbs. (20 Nm).
6. Place the cable assembly in the cable
bracket and secure with the M6 hex nuts.
Finger-tighten the hex nut closest to the
pedal mounting and leave the other nut
loose.
7. Remove the 2-inch block you used in
Step 4.
8. Adjust the hex nut closest to the pedal
mounting until there is a 90' angle
00700-CL222-05, 1 5 March 2005
Section 7. Component Procedures
between the pallet clamp and the left hand
pallet support. Torque the remaining hex
nut to 2 1 ft. lbs. (29 Nm).
Pallet Clamp