Load Sensor Assembly; Tractor Sensor Assembly; Bumper Plate, Location - Toyota 7BPUE15 Service Manual

Section 8. Wire Guidance
Install Kit Components

Load Sensor Assembly

1. Lift the platform, and securely place a
safety stand under the platform. Lower the
platform on the safety stand.
2. Turn key switch OFF and disconnect the
battery.
3. Secure the antenna frame assembly (P/N
00590-02772-71) to the cross tie between
the side cylinders with four hex head cap
screws. See Figure 8-3.
4. Connect the 1L cable assembly (P/N
00590-029 1 1-7 1) to the connector on the
sensor assembly. See Figure 8-4.
Figure Cable Connection
5. Route the cable along the lift hose to the
tractor. Add cable ties loosely as necessary
to hold the cable to the hose. See
Figure 8-5.
N : Tight cable ties will cause the shielded
O TE
sensor cable to break as the lift hose
expands when the platform lifts.
Toyota Orderpicker Model 7BPUE15 Service Manual
6. Connect the JW1 cable to the filter card.
Figure Cable Routing Under Battery to Tractor

Tractor Sensor Assembly

1. Remove the bumper plate. See Figure 8-6.
2. Place tractor sensor assembly (P/N
00590-02842-7 1) on the bumper plate
with the connector jack facing the top of
the bumper plate and secure with four
screws (P/N 00590-03085-7 1). See
Figure 8-7.
3. Connect cable assembly (P/N
00590-45746-71) to the sensor at
connector J1T. See Figure 8-7.
4. Feed the cable through the cutout in the
tractor frame along the right side of the
tractor frame drive unit housing. Secure
the cable to the tractor frame using the
cable straps (P/N 00590-03458-71) and
00700-CL222-05, 1 5 March 2005