Section 7. Component Procedures
Hydraulic Manifold
Hydraulic Manifold
7-86.
Figure
Hydraulic Manifold location
Lower the operator platform before
removing the hydraulic manifold.
Remove
1. Turn key switch OFF and disconnect
battery.
2. Remove tractor covers.
3. Drain hydraulic reservoir. See "Hydraulic
Fluid" on page 7-60.
4. Remove hoses.
5.
Remove the two bolts holding the manifold
to the bracket.
Install
1. Mount manifold to its bracket.
2. Replace the O-rings a t manifold openings.
N
: Lubricate O-rings with clean hydraulic
O TE
fluid before installing.
3. Connect the hoses to the manifold.
4. Fill reservoir. See "Lubrication
Specification Chart" on page A-2.
5.
Install tractor covers.
6. Connect power and test lift system
function before returning truck to service.
Toyota Orderpicker Model 7BPUE 15 Service Manual
00700-CL222-05, 1 5 March 2005
Hydraulic Components