Bottom View Of Housing (Using Mirror); Hydraulic Connection, Side Cylinder, Bottom - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 15 Service Manual
Hydraulic Components
Side Cylinder
Use extreme care whenever the truck is
jacked up. Never block the truck
between the mast and the floor. Keep
hands and feet clear from vehicle while
jacking the truck. After the truck is
jacked, place solid blocks beneath it to
support it. DO NOT rely on the jack
alone to support the truck. See "Jacking
2- 1 1.
Safety" on page
Using a mirror will enable you to see the
N :
OTE
snap ring a t the bottom of each cylinder
housing in the following procedures.
Remove
Elevate the platform far enough to access
1.
the tubing that connects to the bottom of
the lift cylinder but not far enough to
extend the side cylinder. Block the carriage
in place.
2. Remove the tubing from the bottom block
on the cylinder that is to be removed and
cap both the tubing and the fitting to the
lift cylinder.
Figure 7-96. Hydraulic Connection, Side Cylinder, Bottom
3. Unblock and lower the platform to the
floor.
00700-CL222-05, 1 5 March 2005
Section 7. Component Procedures
Remove the bolt in the top of the lift
4.
cylinder that connects it to the bracket on
mast.
5. Elevate the platform until it clears the ram
assembly enough to allow removal
6. Block the carriage and
7. Remove the snap ring from the bottom of
the cylinder. See Figure 7-97.
Figure 7-97. Bottom View of Housing (Using Mirror]
8. Remove the bolt that attaches the cylinder
housing to the main frame of the truck.
See Figure 7-98.
Figure 7-98. Side Cylinder
9. Remove the lift cylinder from the truck.
Side Cylinder
mast.