Toyota Orderpicker Model 7BPUE 15 Service Manual
spring with the tangs straddling the pot
bracket pin. See Figure 7- 16.
N
: Replace the spring if the tangs are not
O TE
parallel. Do not bend the spring.
8. Install the two remaining fiber washers.
9. Install the lift/lower knob. See "Lift/Lower
Knob Installation/Adjustment" on
page 7-2 1.
Travel Pot (VR 1
Disassembly
1. Remove the four hex head cap screws from
the front of the travel pot enclosure and
remove cover. See Figure 7-22.
R e m o v e screws
Figure 7-22. Travel Pot Cover Removal
2. Remove the two pan head machine screws
from the back of the enclosure. Carefully
00700-CL222-05, 1 5 March 2005
)
Section 7. Component Procedures
pull the travel pot/bracket assembly from
the enclosure. See Figures 7-23 and 7-24.
Figure 7-23. Travel Pot Bracket Screws
Figure 7-24
Travel Pot Enclosure (Cover Removed)
3. Loosen the set screw on the gear two full
turns and slide the gear off the shaft. See
Figure 7-25.
4. Remove retaining nut and lock washer
from pot and separate from the bracket.
See Figure 7-25.
Figure 7-25. Travel Pot/Bracket Disassembly
5. Carefully remove heat shrink tubing from
the terminals and identify the wires so
they can be installed in the same location
on the new pot.
Control Handle