Learn Guide Wire Frequency; Learn Wire Guidance Offsets - Toyota 7BPUE15 Service Manual

Section 8. Wire Guidance
Set-Up Procedure

Learn Guide Wire Frequency

N : Make sure the line driver is set up and
OTE
adjusted properly.
1. In manual steer mode, position the truck
to center the tractor end and the load end
sensors over the guide wire
centered.
N : The horn chirps a t approximately 10
OTE
chirps per second when the truck is
centered over the guide wire and if the
present frequency has been learned
previously.
2. Without moving the truck, turn the key
switch off.
3. Enter horn code 3,3.
a. Hold down the horn button and turn the
key switch on. Do not release the horn
yet.
b. Wait for the steer LEDs to stop flashing,
and release the horn button.
c. Press and release the horn button 3
times. Each time you press the button,
a n additional BDI LED will light.
d. Wait for the BDI LEDs to turn off.
e. Press and release the horn button
more times.
f. Wait for the BDI LEDs to turn off.
Wait 10-15 seconds for the truck to learn
4.
the guide wire frequency. During this time,
the following occurs:
BDI LEDs scroll up and down
Horn does not chirp
5. After the BDI stops scrolling, verify the
truck has learned the guide wire
frequency. Observe the following pattern:
Horn chirps a t approximately 10 chirps
per second
Center steer LED flashes continuously
6. If the truck fails to demonstrate the
pattern listed in step 5, repeat the
procedure.
Toyota Orderpicker Model 7BPUE15 Service Manual

Learn Wire Guidance Offsets

N : Make sure the line driver is set u p and
OTE
1. In manual steer mode, position the truck
to center the tractor end and the load end
0.75" 19 sensors over the guide wire
centered.
N : The horn chirps a t approximately 10
OTE
2. Without moving the truck, turn the key
switch off.
3. Enter horn code 3,4.
a. Hold down the horn button and turn the
b. Wait for the steer LEDs to stop flashing,
c. Press and release the horn button 3
d. Wait for the BDI LEDs to turn off.
3 e. Press and release the horn button 4
f. Wait for the BDI LEDs to turn off.
Wait for the center steer LED to start
4.
flashing. (The LED should start flashing in
approximately 8 seconds.)
5. Step on the deadman pedal and wait for
the drive unit to center.
6. Flip the auto/manual switch to auto.
7. Drive tractor-first for approximately 20
feet (6.1 m) and coast to a stop.
N : Do not apply the brake, or drive
OTE
8. Flip the auto/manual switch to manual.
adjusted properly.
chirps per second when the truck is
centered over the guide wire and has
previously learned the present guide
wire frequency.
key switch on. Do not release the horn
yet.
and release the horn button.
times. Each time you press the button,
a n additional BDI LED will light.
more times.
forks-first a t any time during this
procedure.
Travel speed is limited to 2 mph
(3.2 kph).
The chirp pitch changes slightly.
Left and right steer LEDs flash.
00700-CL222-05, 1 5 March 2005
0.75" 19