TECHNOGYM RUN Technical Service Guide
Rev. 1.0
8.
TIGHTENING TORQUES - GREASE -
ADHESIVE & SEALANTS - BELT TENSIONING
- ADJUSTMENTS
8.1 EQUIPMENT LEVELLING
The product must be level for proper operation. To level the product, adjust one of the feet as
shown in the diagram.
Remove the panel (V);
Loosen the locknut (U)
Screw or unscrew the foot (T) until the frame is in a stable position.
After the adjustment, tighten the locknut (U).
Fit the panel (V) back in place.
TSG-00284-EN - Uncontrolled copy if printed
Fig. 53
- 105 -