Adjustments; Tensioning A New Tread Belt - Technogym RUN PERSONAL Service Maintenance Manual

RUN PERSONAL: Service & maintenance manual - rev. 3.1

8. ADJUSTMENTS

8.1. TENSIONING A NEW TREAD BELT

Figure 8.1-1
Figure 8.1-2
1. After replacing the tread belt, place a tape
measure along the centre of the tread belt and
use a pen (or white corrector fluid) to make
two reference marks spaced exactly 1m meter
apart.
2. Alternately lock down the 2 tension adjusting
screws (a) so as to balance the tension
exerted by the belt on the roller bearings,
until the distance between the reference
marks increases by 7mm.
After completing this procedure, any
further adjustments
performed using only the left-hand
tension screw.
CAUTION:
procedure, check the centering of the
tread belt as instructed in paragraph:
8.3. "Centering and adjusting the belt"
should
After completing
Page 8.1
be
this