Instrument Preparation; Registering A Bluetooth Address - Konica Minolta CM-25cG Instruction Manual

Instrument Preparation

{ „
Connecting the Bluetooth module to the instrument, and turn ON the instrument's Bluetooth function. (Refer to
page 99.)
Until the instrument's Bluetooth function is turned ON, registration and automatic printing configuration of
Notes
the Bluetooth printer/reader is not possible.

Registering a Bluetooth Address

… „
Operating Procedure Start the procedure from the <Setting> - <Communication setup> screen.
1
Use [] or [] to move the cursor to "Printer address" / "Scanner address", and then press the
[Confirmation] key.
The "Printer address" / "Scanner address" screen is displayed.
Sample
Auto print
Bluetooth
Meter PIN code
Printer address
2
Enter the address of the Bluetooth device to be connected.
Sample
Printer address
3
After inputting the characters, move the cursor to [OK] and press the [Confirmation] key.
The printer/reader will be registered as an I/O device for the instrument, and the display will return to the
<Communication setup> screen.
If [ESC] is pressed during configuration, or if the cursor is moved to "Cancel" and the [Confirmation] key is pressed,
Memo
the settings will not be changed and the screen will return to the <Communication setup> screen.
0003 Bumper
Setting
Communication setup
OFF
ON
0000
000000000000
0003Bumper45
0123456789AB
0 1 2 3 4 5
6 7 8 9
A B C D E F
OK Cancel
Sample 0003 Bumper
Setting
Communication setup
Printer address
000000000000
Printer PIN code
0000
Scanner address
000000000000
Scanner PIN code
0000
Sample
0003Bumper45
Scanner address
0123456789AB
0 1 2 3 4 5
6 7 8 9
A B C D E F
OK Cancel
4
104