X84; „ Measurement/Data Display Screen; Measurement/Data Display Screen - Konica Minolta CM-25cG Instruction Manual

Measurement/Data Display Screen

„ „
Target List Screen
• For every data entry, the target No. and name is displayed in the column above, and the measurement date and
time are displayed in the column below. A pseudocolor is displayed at the right end only if data exists. However,
no pseudocolor is displayed when measuring only gloss.
• The cursor will appear at the currently selected target.
• Press the [Confirmation] key or [ESC] to bring up the target detail screen and display the currently selected
target's detailed data.
• Press [] to select (move the cursor to) the previous target.
• Press [] to select (move the cursor to) the following target.
• Press [] to display the previous list screen. The cursor will move to the top target.
• Press [] to display the following list screen. The cursor will move to the top target.
Target Detail Screen
• The target No. and name is displayed below the target tab.
• Failure to set Observer/Illuminant 2 will cause the data value column to be blank.
• The Gloss column will be blank if the measurement mode is set to "Color only".
• The measurement date and time as well as the set group number will be displayed below the data value
column.
• The measurement area will be displayed in the lower-right corner of the data value column.
• An exclamation mark
the calibration interval has arrived, or when the result is outside the guaranteed range.
• A display showing the overall page count and the position on the current page is available at the bottom of the
screen.
• The number of pages to display is determined by the <Display type> setting.
• Press [ESC] to bring up the Target list screen. The cursor will appear at the currently selected target.
• Press [] to display the previous target.
• Press [] to display the following target.
• Press [] to bring up the previously displayed page.
• Press [] to bring up the following displayed page.
Common Aspects of List and Detail Screens
• The settings for the currently selected filter are displayed to the right of the Target tab.
• If no data exists, the data value column will be blank.
• Press [ ] to bring up the Sample screen.
• Press [MENU] to bring up the <Target menu> screen.
• Pressing the measurement button will cause the <Measuring> screen to be displayed and measurement to
begin.
• When <Protect data> is turned ON, a message saying so will be displayed and measurement will not be
possible. Select "OK" to return to the previous screen.
• If calibration is required (if calibration has not yet been performed or if the calibration interval has been
exceeded), a message will be displayed prompting calibration. Select "OK" to bring up the calibration screen.
Selecting "Cancel" will cause the display to return to the previous screen without performing calibration.
• If data already exists, an overwrite confirmation message will appear. Select "OK" or press the measurement
button to measure. Selecting "Cancel" will cause the display to return to the previous screen without
performing measurement.
• When <Beep> is ON, the buzzer will go off once after successful completion and 3 times when an error occurs.
• After successful completion of the measurement, the data will be saved to the selected target number.
• Measurements outside the measurement range will be indicated by "Out of Guaranteed Range" displayed for
the measurement value on the screen.
• If an error occurs during measurement, an error indication message will be displayed. Select "OK" to return to
the previous screen.
• In general, the screen will return to the previous screen (page) after measurement. However, if the manual
average count is two or more, the Manual average screen will be displayed (refer to page 77).
39
will be displayed when a measurement is performed with an insufficient illumination or
!