X84; „ White Calibration And Gloss Calibration; White Calibration And Gloss Calibration - Konica Minolta CM-25cG Instruction Manual

White Calibration and Gloss Calibration

„ „
A message prompting white calibration is displayed on the instrument after the power is turned ON.
• If the calibration interval is turned ON and a time is configured, a message prompting white calibration will be
Memo
displayed the next time the power is turned ON or when measurement is performed after the set time has passed
since the previous white calibration. (Refer to page 110 "Calibration Interval Messages".)
• The reading may fluctuate slightly due to changes in the ambient temperature or due to heat generation caused by
repeated operation of the instrument. In such cases, perform white calibration regularly.
• Calibration details may vary according to the measurement mode (Refer to page 74). When the measurement
mode is set to "Color & Gloss", white calibration and gloss calibration will be performed. When the mode is set to
"Color only", only white calibration will be performed. When the mode is set to "Gloss only", only gloss calibration
will be performed.
• White calibration must be performed at the same temperature at which measurement will be performed.
Notes
• Perform white calibration after the instrument has had time to adapt to the ambient temperature.
Operating Procedure Start the procedure from the measurement screen.
Although white calibration can be performed from the prompt when the power is turned ON and from the screen
following zero calibration, the following explains the procedure to perform white calibration from the
measurement screen.
1
Press [MENU], and then use [] or [] to display the
<Calibration> screen.
• The following screen prompting calibration is
Notes
displayed when the instrument starts up. If zero
calibration has not been performed, the cursor will
appear on "Calibration (Including Zero Cal.)".
Otherwise, the cursor will appear on "Calibration
(Excluding Zero Cal.)".
Calibration
Zero calibration date
White calibration date
Gloss calibration date
2
Use [] or [] to move the cursor to "Calibration
(Excluding Zero Cal.)", and then press the
[Confirmation] key.
Calibration
(Excluding Zero Cal.)
Calibration
(Including Zero Cal.)
2016/07/21 08:46:13
2016/07/21 08:46:32
2016/07/21 08:46:54
Sample 0003 Bumper
Calibration
Calibration
(Excluding Zero Cal.)
Calibration
(Including Zero Cal.)
Zero calibration date
2016/07/21 08:46:13
White calibration date
2016/07/21 08:46:32
Gloss calibration date
2016/07/21 08:46:54
2
34