X85; „ Set Group - Konica Minolta CM-25cG Instruction Manual

Set Group
… „
In order to facilitate classification of targets into groups, up to five groups to which data should be categorized can
be configured. After the targets have been registered to a group, the filtering function can be used to display only
the selected target data. This section describes the registration of a group.
• If a new target color is measured, the measurement will be assigned to the appropriate group according to the
Memo
default settings.
• Display the group of the target color to be set on the <Target> screen in advance.
Operating Procedure Start the procedure from the <Target menu> - <Data management> screen.
1
Use [] or [] to move the cursor to "Set group",
and then press the [Confirmation] key.
The <Edit group> screen is displayed.
2
Use [] or [] to move to the cursor to the group
number column to which the current target color
should be applied, and then press the
[Confirmation] key.
3
Use [] or [] to move the cursor to select the
group value to which the target color should be
applied, and then press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Target> screen.
Group names configured in advance through <Default data
Memo
setup> in accordance with group numbers are displayed.
4
Select "OK". Selecting "Cancel" will cause the
display to return to the <Data management> screen
without changing the settings.
If [ESC] is pressed without pressing the [Confirmation]
Notes
key, the settings will not be changed and the screen will
return to the <Data management> screen.
Target
Target menu [0003]
Data management
Delete data
Set group
[01]
Change list position
Edit Target filter
OFF
Edit group
01 Panel1
02
03
00
00
OK Cancel
2
56