Z „ Connecting Via Usb Cable; Connecting Via Usb Cable - Konica Minolta CM-25cG Instruction Manual

Connecting via USB Cable

z „
Connect the instrument to a PC with the supplied USB cable IF-A26 (2 m).
• To connect the instrument to a PC, the dedicated USB driver must be installed. The necessary drivers will be
Notes
installed automatically. To install the drivers manually, use the drivers included with the software (such as
the optional SpectraMagic DX software).
• The instrument can be powered through the USB cable. (The battery must always be installed.)
• When power is being supplied via USB, the charging lamp on the instrument's panel will light up orange
while charging. When charging is complete, the lamp will turn green.
• Make sure that the USB connector plug is oriented correctly and connected securely.
• When connecting/disconnecting the USB cable, be sure to hold the connector plug. Do not pull on or
forcibly bend the cable. Otherwise, wire breakage may result.
• Make sure that the cable has sufficient length. Putting tension on the cable may cause connection failure or
wire breakage.
• Firmly push in the USB cable connector that matches the shape of the port (connection terminal) until it can
go in no further.
The USB communication port of the instrument conforms to USB 2.0.
Memo
Operating Procedure
1
Open the connector's protective cover, and connect
the USB cable mini plug to the USB port on the
instrument.
‹ Fully insert the connector and ensure the connection is ‹
secure.
2
Connect the A connector of the USB cable to the USB
port on the PC.
3
Turn the instrument power ON.
‹ When installation of the USB driver is prompted, ‹
specify the USB driver included with the software to
complete the installation.
4
98