X85; „ Tolerance Settings - Konica Minolta CM-25cG Instruction Manual

Tolerance Settings
… „
Specify the tolerance used for pass/fail judgment of measured data for each target color.
Operating Procedure Start the procedure from the <Target menu> - <Pass/Fail> screen.
1
Use [] or [] to move the cursor to "Edit
tolerance", and then press the [Confirmation] key.
The tolerance list screen is displayed.
2
Use [] or [] to move the cursor to the item to be
set, and then press the [Confirmation] key.
The <Edit tolerance> screen is displayed.
3
Use []/[] or []/[] to move the cursor to the
item to set and press the [Confirmation] key to
change the item.
• When the selected item is not currently checked,
pressing the [Confirmation] key causes the item to be
checked, after which the setting value can be changed.
• Press [] or [] to move the cursor to the setting value
area. Pressing the [Confirmation] key causes the cursor
to appear on the value. Press [] or [] to change the
value.
Move the cursor between the digits of the value by
pressing [] or [].
Settings
x / y
{ „
Color difference equation/MI : 0.00 to 20.00
{ „
Other than the above
{ „
• Press the [Confirmation] key to confirm every time the
setting of an item is changed.
4
After all settings have been configured, use [] or
[] to move the cursor to "OK", and then press the
[Confirmation] key.
The setting is confirmed and the screen returns to the
<Pass/Fail> screen.
If [ESC] is pressed during setup, the settings will not be
changed and the screen will return to the <Pass/Fail>
screen.
5
Press [ESC] to return to the <Pass/Fail> screen.
: -0.2000 to 0.2000
: -20.00 to 20.00
Sample
Target menu [0003]
Pass/Fail
Edit tolerance
Warning level
0%
Parametric coef.
Target
Panel
0004
Edit tolerance
10°/D65 2°/C
1.00 1.00
∆L*
-1.00 -1.00
1.00 1.00
∆a*
-1.00 -1.00
1.00 1.00
∆b*
-1.00 -1.00
1.00 1.00
∆C*
-1.00 -1.00
1.00 1.00
∆H*
1.00 1.00
Edit tolerance
∆L*
+09.09
10°/D65
−09.29
+09.29
2°/C
−09.29
OK Cancel
2
62