X85; „ Change List Position - Konica Minolta CM-25cG Instruction Manual

Change List Position
… „
Specifying target numbers allows for specified targets to be displayed without the need to scroll the screen.
Operating Procedure
1
Use [] or [] to move the cursor to "Change list
position", and then press the [Confirmation] key.
The <Change list position> screen is displayed.
2
 and  will be displayed above and below the data
number. Use [] or [] to specify a value. Use []
or [] to move between digits.
3
Press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Target> screen.
If [ESC] is pressed without pressing the [Confirmation]
Notes
key, the settings will not be changed and the screen will
return to the <Data management> screen.
57
Start the procedure from the <Target menu> - <Data management> screen.
Target
Target menu [0003]
Data management
Delete data
Set group
[01]
Change list position
Edit Target filter
OFF
Change list position
0808: Bumper45
0808 / 2500
OK Cancel