X85; „ Calibration Interval Messages - Konica Minolta CM-25cG Instruction Manual

Calibration Interval Messages
… „
If the instrument has not been used for an extended period of time since the previous measurement, a message
prompting white calibration will appear after start-up and before measurement. The time interval between the
previous calibration and when the message is displayed can be configured.
The interval until the calibration is displayed is set to "8 (hour)" when the instrument is shipped from the factory.
Memo
Operating Procedure Start the procedure from the <Calibration setup> screen.
1
Use [] or [] to move the cursor to "Calibration
interval", and then press the [Confirmation] key.
2
 and  will be displayed above and below the
numbers representing the time until the message is
displayed. Use [] or [] to specify a value.
Settings
1 to 24 h: Set the time interval between the previous
{ „
calibration and when the message should be
displayed to between 1 and 24 hours.
3
Press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Calibration setup> screen.
If [ESC] is pressed without pressing the [Confirmation]
Notes
key, the settings will not be changed and the screen will
return to the <Calibration setup> screen.
Sample 0003 Bumper
Setting
Calibration setup
Calibration interval
8 (hour)
Annual calibration
ON
User calibration
OFF
Calibration interval
08 / 24
OK Cancel
4
110