Setting A Specimen; X84; „ Viewfinder; Viewfinder - Konica Minolta CM-25cG Instruction Manual

Setting a Specimen

To measure with this instrument, select the measurement area and set the instrument on the specimen. Either
MAV or SAV can be selected as the measurement area depending on the specimen being measured and the
application.
Switch the measurement area to be measured using the measurement area switch.
Notes

Viewfinder

„ „
This instrument allows users to check the measurement points for a specimen when using the instrument for
measurement.
How to Use
1
Set the instrument on top of the specimen.
2
Slide the viewfinder lever to open the viewfinder. (The viewfinder and viewfinder levers are
located on the left and right side of the instrument. Either can be used to confirm the position of
the sample.)
3
As the viewfinder opens, a white LED will turn ON, illuminating the specimen within the range of
measurement according to the set measurement area (MAV/SAV).
The LED illuminates the MAV measurement range at first. When the measurement range is set to SAV, the SAV
Memo
measurement range is illuminated when the measurement button is pushed.
4
Look into the viewfinder and adjust the position of the specimen.
Look into the viewfinder from an angle that allows the user to see the measuring port.
Memo
5
Close the viewfinder. (The white LED will turn OFF.)
If the reflectance of the specimen to be measured is low, the measurement range may not be clearly visible
Notes
even when illuminated by a white LED. Also, if the specimen has a mirror surface or a surface similar to a
mirror surface, the illumination light may not be clearly visible. In such cases, use the optional stapler type
target mask (CM-A216).
37
Viewfinder
Viewfinder lever