X84; „ Conventions; X85; „ Instrument Firmware Version - Konica Minolta CM-25cG Instruction Manual

Conventions
„ „
This manual describes how to safely operate the CM-25cG using a specific procedure to perform measurement.
· Viewing Pages
Symbols used in this manual are explained below.
* Explanatory pages are constructed as follows. (The content of the explanatory illustration will differ from the
actual page.)
* Display screenshots used in the explanations may include different content and values, and may have a different
layout than the actual display.
Procedure
Indicates an
operating procedure.
Settings
Describes ranges and
provides
explanations
regarding settings for
the screen in
question.
Memo
Provides useful
information,
supplementary
explanations, and
similar details.
Notes
Provides essential
information for
correct operation of
the instrument.
Always read this
information before
operating the
instrument.
Instrument Firmware Version
… „
The version of the instrument firmware can be confirmed on the <Instrument info.> screen. For details, refer to
page 114 "Displaying the Instrument Information" in this manual.
9
Display Type
… „
Configure the display type for the measurement results.
All display types are selected when the instrument is shipped from the factory.
Memo
Operating Procedure Start the procedure from the <Measurement cond.> - <Display cond.> screen.
1
Use [] or [] to move the cursor to "Display type",
and then press the [Confirmation] key.
The <Display type> screen is displayed.
2
Use [] or [] to move the cursor to the desired
display type, and then press the [Confirmation] key.
Selections
Absolute value: Displays the absolute value of the
… „
colorimetric and the gloss value.
Difference: Displays the color difference and gloss value
… „
difference against the target color. The measurement
that failed the pass/fail judgment based on the
tolerance will be highlighted in red.
Abs. & Diff.: Displays the absolute value and the color
… „
difference and gloss value difference against the target
color. The measurement that failed the pass/fail
judgment based on the tolerance will be highlighted in
red.
… „ Pass/Fail: Determines whether the color difference and gloss value difference related to the target are
within the tolerance range set in advance. If within the tolerance, the judgment will be displayed as "Pass".
If even one difference is not within the tolerance, the judgment will be displayed as "Fail".
Custom: Displays the display color value and index set under "Custom" as the two illuminants.
… „
… „ Abs. Graph: Displays a graph of the absolute value of the colorimetric and the gloss value.
Diff. Graph: Displays a graph showing the color difference and gloss value difference against the target
… „
color.
Spectral Graph: Displays a graph showing the spectral reflectance. The [Confirmation] key can be used to
… „
move the wavelength displaying the spectral reflectance value.
A check mark means the item is selected.
Memo
3
After all settings have been configured, use [] or [] to move the cursor to "OK", and then press
the [Confirmation] key.
The selection is confirmed and the screen returns to the previous screen.
If [ESC] is pressed without pressing the [Confirmation] key, the settings will not be changed and the screen
Notes
will return to the <Display cond.> screen.
83
Sample 0003 Bumper
Start screen
Measurement cond.
Indicates the initial
Display cond.
screen from which
Display type
Color space
the operation is
L*C*h
Equation
CMC commenced.
Custom 1
L
Display type
Screenshot
Absolute value
Difference
Abs. & Diff.
Indicates the state of
Pass/Fail
Custom
Abs. Graph
the screen when the
Diff. Graph
Spectral Graph
operation described
OK Cancel
in the procedure to
the left is carried out.