X85; „ Auto Average (1 To 10) - Konica Minolta CM-25cG Instruction Manual

Auto Average (1 to 10)
… „
Specify the number of measurements for auto averaging. Every time the measurement button is pressed, the
average of the data obtained from the specified number of continuous measurements is determined as sample
data.
"1 Times" is set as the number of measurements for automatic averaging when the instrument is shipped from the
Memo
factory.
Operating Procedure Start the procedure from the <Measurement cond.> - <Measurement setup> screen.
1
Use [] or [] to move the cursor to "Auto
average", and then press the [Confirmation] key.
2
 and  will be displayed above and below the
count in the count selection. Use [] or [] to
specify a value.
Settings
1 to 10 times:
{ „
Specify the number of measurements, from 1 to 10, to
perform when using auto averaging.
3
Press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Measurement setup> screen.
If [ESC] is pressed without pressing the [Confirmation]
Notes
key, the settings will not be changed and the screen will
return to the <Measurement setup> screen.
Sample 0003 Bumper
Measurement cond.
Measurement setup
Auto average
1 Times
Manual average
1 Times
Manual average option
Manual save
Auto average
08 / 10
3
76