X85; „ Parametric Coefficient Setting - Konica Minolta CM-25cG Instruction Manual

Parametric Coefficient Setting
… „
Specify the parametric coefficient used for pass/fail judgment of measured data for each target color.
Operating Procedure Start the procedure from the <Target menu> - <Pass/Fail> screen.
1
Use [] or [] to move the cursor to "Parametric
coef.", and then press the [Confirmation] key.
The <Parametric coef.> screen is displayed.
2
Use [] or [] to move the cursor to the item to be
set, and then press the [Confirmation] key.
The <Parametric coef.> edit screen is displayed.
3
Use [] or [] to move the cursor to the item to set
and press the [Confirmation] key to change the
item.
• Pressing the [Confirmation] key causes the cursor to
appear on the value. Press [] or [] to change the
value. Move the cursor between the digits of the value by
pressing [] or [].
Settings
0.01 to 9.99
{ „
• Press the [Confirmation] key to confirm every time the
setting of an item is changed.
4
After all settings have been configured, use [] or
[] to move the cursor to "OK", and then press the
[Confirmation] key.
The setting is confirmed and the screen returns to the
<Pass/Fail> screen.
If [ESC] is pressed during setup, the settings will not be
Notes
changed and the screen will return to the <Pass/Fail>
screen.
5
Press [ESC] to return to the <Pass/Fail> screen.
Sample
Target menu [0003]
Pass/Fail
Edit tolerance
Warning level
0%
Parametric coef.
Parametric coef.
9.29
I (CMC):
9.29
C (CMC):
9.29
I (∆E*94):
9.29
C (∆E*94):
9.29
h (∆E*94):
9.29
I (∆E00):
9.29
G (∆E00):
Parametric coef.
9.09
I (CMC):
9.29
C (CMC):
9.29
I (∆E*94):
9.29
C (∆E*94):
9.29
h (∆E*94):
OK Cancel
2
64