X85; „ Set Group - Konica Minolta CM-25cG Instruction Manual

Set Group
… „
Create groups for registering targets in advance.
No group name is set when the instrument is shipped from the factory.
Memo
Operating Procedure
1
Use [] or [] to move the cursor to "Set group",
and then press the [Confirmation] key.
The <Set group> screen is displayed.
The currently selected group numbers and names will be
displayed in the upper table. The group is set by default
when the target is measured.
The cursor will appear in the lower area with group
numbers. Configure the group name.
2
Use [] or [] to move the cursor to the group
number of the group to edit. Numbers with blank
names have not yet been set as a group. Assigning a
name will register the number as a group. Users can
also edit the names of existing groups.
Groups 01 through 50 can be set with up to 5 groups being
available for registration.
3
Check the box of the number to register to edit the
name.
The <Edit name> screen is displayed.
Checking the box registers the number to the table above,
Memo
and when the target is measured, the number is
automatically assigned to the appropriate group. To delete
the information from the table, uncheck the box.
4
Use []/[] or []/[] to move the cursor
between characters, and then press the
[Confirmation] key.
• Up to 30 characters can be used.
• The selected character is displayed in the text box.
69
Start the procedure from the <Setting> - <Default data setup> screen.
Sample 0003 Bumper
Setting
Default data setup
Default tolerance
Warning level
0%
Parametric coef.
Set group
Set group
01 Panel1
01: Panel1
02: Panel2
03: Panel3
04:
05:
0003Bumper45
ABCDEFGH|
A B C D E F
G H I J K L
M N O P Q R
S T U V W X
Y Z . _ ( )
ABC/abc/123
OK Cancel