Voltech ATi User Manual page 390

T T
ESTS AND EST
•
Select OK. The test specification will then be displayed in the program
window.
Note that although resistors should be fitted to the fixture, there is no need to
enter their values here since the RESP test result is the difference between
two ratios based on the same resistor values. The resistor values cancel out in
the calculation.
If the "User Offset Enabled" check box is checked, a value can be entered into
the edit box. The value entered is then added to any results returned from the
AT tester.
P 7-92
AGE
C
ONDITIONS
V AT U
OLTECH I SER
M
ANUAL