Dell PowerConnect J-EX4200-24T Software Manual page 3272

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Output Fields
Table 427: show route forwarding-table Output Fields
Field Name Field Description
Name of the routing table (for example,
Routing table
Address family (for example,
Address family
Destination Destination of the route.
Route Type (Type) How the route was placed into the forwarding table. When the
is used, the route type might be abbreviated (as shown in parentheses):
cloned
destination
destination down
unreachable.
interface cloned
route down
ignore
interface
permanent
initialized.
user
configuration.
Route reference Number of routes to reference.
(RtRef)
Route type flags:
Flags
none
accounting
cached
incoming-iface interface-number
prefix load balance
sent to PFE
static
IP address of the next hop to the destination.
Nexthop
3200
show route forwarding-table ccc on page 3203
show route forwarding-table family on page 3204
show route forwarding-table label on page 3204
show route forwarding-table matching on page 3204
show route forwarding-table multicast on page 3205
Table 427 on page 3200 lists the output fields for the
Output fields are listed in the approximate order in which they appear. Field names might
be abbreviated (as shown in parentheses) when no level of output is specified or when
the keyword is used instead of the
detail
,
IP IPv6
( )—(TCP or multicast only) Cloned route.
clon
( dest )—Remote addresses directly reachable through an interface.
( )—Destination route for which the interface is
iddn
( )—Cloned route for which the interface is unreachable.
ifcl
( )—Interface route for which the interface is unreachable.
ifdn
( ignr )—Ignore this route.
( )—Installed as a result of configuring an interface.
intf
( )—Routes installed by the kernel when the routing table is
perm
—Routes installed by the routing protocol process or as a result of the
—No flags are enabled.
—Route has accounting enabled.
—Cache route.
—Check against incoming interface.
—Load balancing is enabled for this prefix.
—Route has been sent to the Packet Forwarding Engine.
—Static route.
show route forwarding-table
keyword.
extensive
, , ).
inet inet6 mpls
, , ).
ISO MPLS
detail
command.
Level of Output
All levels
All levels
detail, extensive
keyword All levels
detail, extensive
extensive
detail, extensive