Dell PowerConnect J-EX4200-24T Software Manual page 3336

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 438: Port Mirroring Configuration Settings
Field Function
Analyzer Specifies the name of the analyzer.
Name
3264
Packets entering or exiting a port
Packets entering a VLAN on J-EX4200 switches
Packets exiting a VLAN on J-EX8200 switches
To configure port mirroring on a J-EX Series switch using the J-Web interface:
Select Configure > Security
1.
The first part of the screen displays analyzer details such as the name, status, analyzer
port, ratio, and loss priority.
The second part of the screen lists ingress and egress ports of the selected analyzer.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes (J-Web Procedure)"
on page 334 for details about all commit options.
Click one:
2.
Add—Add an analyzer. Enter information as specified in Table 438 on page 3264.
Edit—Modify details of the selected analyzer. Enter information as specified in Table
438 on page 3264.
Delete—Delete the selected analyzer.
Enable/Disable—Enable or disable the selected analyzer (toggle).
NOTE: On J-EX4200 switches, only one analyzer can be enabled at a time.
On J-EX8200 switches, a maximum of seven analyzers can be enabled.
NOTE: When an analyzer is deleted or disabled, any filter association is
removed.
> Port Mirroring .
Commit Options
Your Action
Type a name for the analyzer.
> . See "Using the
Commit