Connecting And Configuring A J-Ex Series Switch (J-Web Procedure) - Dell PowerConnect J-EX4200 Hardware Manual

Connecting and Configuring a J-EX Series Switch (J-Web Procedure)

There are two ways to connect and configure a J-EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the J-Web procedure.
NOTE: Before you begin the configuration, enable a DHCP client on the
management PC you will connect to the switch so that the switch can obtain
an IP address dynamically.
NOTE: Read the following steps before you begin the configuration. You
must complete the initial configuration using EZSetup within 10 minutes. The
switch exits EZSetup after 10 minutes and reverts to the factory default
configuration, and the PC loses connectivity to the switch. The LCD displays
a count-down timer when the switch is in initial setup mode.
To connect and configure the switch using the J-Web interface:
To transition the switch into initial setup mode, use the
1.
to the right of the LCD panel (see Figure 55 on page 133):
Figure 55: LCD Panel in a J-EX4200 Switch
a. Press the button until you see
Menu
button.
b. Press until you see
Menu
If EZSetup does not appear as an option in the menu, select Factory Default to
return the switch to the factory default configuration. EZSetup is displayed in the
menu only when the switch is set to the factory default configuration.
c. Press to confirm setup and continue with EZSetup.
Enter
Connect the Ethernet cable from the Ethernet port on the PC to port 0 (
2.
on the front panel of the switch.
The port is configured as the DHCP server with the default IP address,
switch can assign an IP address to the management PC in the IP address range
192.168.1.2 through 192.168.1.253
From the PC, open a Web browser, type http://192.168.1.1 in the address field, and
3.
press Enter.
Chapter 12: Performing Initial Configuration
Menu
MAINTENANCE MENU
. Then press
ENTER EZSetup
.
and buttons located
Enter
. Then press the
Enter
.
Enter
ge-0/0/0 )
. The
192.168.1.1
133