Alcatel-Lucent 7710 SR Configuration Manual page 161

Management Ethernet Configuration
address
Syntax [no] address ip-prefix/ip-prefix-length [active | standby]
Context bof
Description
This command assigns an IP address to the management Ethernet port on the
configuration and the Boot Option File (BOF) . Deleting a BOF address entry is not allowed from a
Telnet session.
The no form of the command deletes the IP address from the CPM Ethernet port.
Default
no address — There are no IP addresses assigned to
Parameters ip-prefix/ip-prefix-length — The destination address of the aggregate route in dotted decimal notation.
active | standby — Specifies which
autonegotiate
Syntax [no] autonegotiate [limited]
Context bof
Description This command enables speed and duplex autonegotiation on the management Ethernet port in the
running configuration and the Boot Option File (BOF).
When autonegotiation is enabled, the link attempts to automatically negotiate the link speed and
duplex parameters. If autonegotiation is enabled, then the configured duplex and speed parameters
are ignored.
The no form of the command disables the autonegotiate feature on this port.
autonegotiate — Autonegotiation is enabled on the management Ethernet port.
Parameters limited — Specifies ethernet ports to be configurable to use link autonegotiation but with only a
7710 SR OS Basic System Configuration Guide
Values
ipv4-prefix
ipv4-prefix-length
ipv6-prefix
ipv6-prefix-length
CCM
Ethernet or the standby
Default
active
single speed/duplex combination advertised. This allows a specific speed/duplex to be guaran-
teed without having to turn off autonegotiation, which is not allowed for 1000BASE-T.
CCM
Ethernet ports.
a.b.c.d (host bits must be 0)
0 — 32
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
0 — 128
CCM
Ethernet address is being configured: the active
Ethernet.
Boot Option Files
CCM
in the running
CCM
Page 161