System Information Commands
atm
Syntax
atm
Context
config>system
Description
This command enables the context to configure system-wide ATM parameters.
atm-location-id
Syntax
atm-location-id location-id
Context
config>system
Description
This command indicates the location ID for ATM OAM.
Refer to the 7710 SR OS Services Guide for information about ATM QoS policies and ATM-related
service parameters.
Default
no atm-location-id
Parameters
location-id — Specify the 16 octets that identifies the system loopback location IDas required by the
oam
Syntax
oam
Context
config>system>atm
Description
This command configures system-wide ATM parameters.
7710 SR OS Basic System Configuration Guide
ATM OAM Loopback capability. This textual convention is defined in ITU-T standard I.610.
Invalid values include a location ID where the first octet is : 00, FF, 6A
Acceptable location-ids include values where the first octet is: 01, 03
Other values are not accepted.
Values
01:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00
System Management
Page 279