Table of Contents
Advertisement
Common Configuration Tasks
A:sim1>config>system>time#
The following example in the config context shows NTP enabled with the broadcast command
configured. At this level, the NTP broadcast commands are displayed at the end of the output after
the router interfaces are shown.
A:sim1>config info
....
#--------------------------------------------------
echo "System Time NTP Configuration"
#--------------------------------------------------
system
exit
A:sim1>config
Broadcastclient
The
broadcastclient
interface..
CLI Syntax: config>system>time>ntp
Example
The following example shows NTP enabled with the
A:ALA-12>config>system>time# info
----------------------------------------------
----------------------------------------------
A:ALA-12>config>system>time#
Page 224
exit
time
ntp
broadcast interface toboth
exit
exit
command enables listening to NTP broadcast messages on the specified
:
config>system>time>ntp#
config>system>time>ntp# broadcastclient interface int11
config>system>time>ntp# no shutdown
ntp
broadcastclient interface int11
no shutdown
exit
dst-zone PT
start second sunday april 02:00
end first sunday october 02:00
offset 0
exit
zone UTC
7710 SR OS Basic System Configuration Guide
broadcastclient[router router-name] {interface
ip-int-name} [authenticate]
broadcastclient
parameter enabled.
Advertisement
Table of Contents
