Table of Contents
Advertisement
Server
The Server command is used when the node should operate in client mode with the NTP server
specified in the address field. Use the no form of this command to remove the server with the
specified address from the configuration.
Up to five NTP servers can be configured.
CLI Syntax: config>system>time>ntp
Example
The following example shows NTP enabled with the
A:sim1>config>system>time>ntp# info
----------------------------------------------
----------------------------------------------
A:sim1>config>system>time>ntp#
7710 SR OS Basic System Configuration Guide
server ip-address [key-id key-id] [version version]
[prefer]
:
config>system>time>ntp#
config>system>time>ntp# server 192.168.1.1 key-id 1
config>system>time>ntp# no shutdown
no shutdown
server 192.168.1.1 key 1
System Management
command configured.
server
Page 227
Advertisement
Table of Contents
