Generic Commands
Default
Parameters
Page 118
If no compact flash is present and the drive is not shut down the LED is unlit.
State:
admin = up, operational = down, equipped = no
Ejecting a compact flash:
The compact flash drive should be shut down before ejecting a compact flash card. The LED
should turn to solid (not blinking) amber. This is the only mode to safely remove the flash card.
If a compact flash drive is not shut down before a compact flash is ejected, the LED blinks amber
for approximately 5 seconds before shutting off.
State:
admin = down, operational = down, equipped = yes
The shutdown or no shutdown state is not saved in the configuration file. Following a reboot all
compact flash drives are in their default state.
no shutdown — compact flash device administratively enabled
cflash-id — Enter the compact flash slot ID to be shut down or enabled. When a specific cflash-id is
specified, then that drive is shutdown. If no cflash-id is specified, the drive referred to by the cur-
rent working directory is assumed. If a slot number is not specified, then the active CFM is
assumed.
Default
The current compact flash device
Values
cf1:, cf1-A:, cf1-B:, cf2:, cf2-A:, cf2-B:, cf3:, cf3-A:, cf3-B:
active — If active is selected, then all drives on the active CFM are shutdown or enabled.
standby — If standby is selected, then all drives on the standby CFM are shutdown or enabled.
Note: When both active and standby keywords are specified, then all drives on both CFMs are
shutdown.
7710 SR OS Basic System Configuration Guide