Table of Contents
Advertisement
System Command Reference
Parameters
lacp-system-priority — Specifies the LACP system priority.
location
Syntax
location location
no location
Context
config>system
Description
This command creates a text string that identifies the system location for the device.
Only one location can be configured. If multiple locations are configured, the last one entered
overwrites the previous entry.
The no form of the command reverts to the default value.
Default
none — No system location is configured.
Parameters
location — Enter the location as a character string. The string may be up to 80 characters long. Any
name
Syntax
name system-name
no name
Context
config>system
Description
This command creates a system name string for the device.
For example, system-name parameter ALA-1 for the name command configures the device name as
ALA-1.
ABC>config>system# name "ALA-1"
ALA-1>config>system#
Only one system name can be configured. If multiple system names are configured, the last one
encountered overwrites the previous entry.
The no form of the command reverts to the default value.
Default
The default system name is set to the chassis serial number which is read from the backplane
EEPROM.
Parameters
system-name — Enter the system name as a character string. The string may be up to 32 characters
Page 286
Values
1 — 65535
printable, seven-bit ASCII characters can be used within the string. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
long. Any printable, seven-bit ASCII characters can be used within the string. If the string
contains special characters (#, $, spaces, etc.), the entire string must be enclosed within double
quotes.
7710 SR OS Basic System Configuration Guide
Advertisement
Table of Contents
