Returning Oracle Database Appliance (Original Version) To Operation; Installing The Server Node Top Cover - Oracle Database Appliance Service Manual

Note -
the second server node.
Refer to the Getting Started Guide and Administration and Reference Guide for
5.
any instructions or commands required to return the appliance to service.
Returning Oracle Database Appliance (Original Version) to
Operation
This section describes returning Oracle Database Appliance (original version) to operation after
servicing. If you have Oracle Database Appliance X3-2, Oracle Database Appliance X4-2, or
Oracle Database Appliance X5-2, go to
X5-2 to Operation" on page
"Installing the Server Node Top Cover" on page 139
■
"Installing a Server Node Into the System Chassis" on page 140
■
"Powering On Oracle Database Appliance (Original Version)" on page 142
■

Installing the Server Node Top Cover

If you removed the top cover from an Oracle Database Appliance (original version) server
node, perform the following procedure to replace it.
Caution -
Caution -
Install Server Node Top Cover
1. Place the top cover down on the server node so that it hangs over the front of
the chassis by 0.5 inches (12.7 mm).
Ensure that all six of the standoffs on the underside of the cover (three on each
2.
side) fit into the slots on the top of the chassis side walls.
If you powered off both server nodes prior to servicing, repeat steps 3 and 4 to power on
137.
Hazardous voltage present. Do not run the system with the top cover removed.
Equipment damage. Install the top cover properly before starting the system.

Returning Oracle Database Appliance (Original Version) to Operation

"Returning Oracle Database Appliance X3-2/X4-2/
Chapter 6 • Returning Oracle Database Appliance to Operation 139