Illustra Pro PTZ 30x Configuration User Manual page 95

TCP/IP
Procedure 8-1 Configure the IPv4 Settings
Step Action
1 Select Setup on the GUI banner to display the setup menus.
2 Select TCP/IP from the Network menu.
3 Select the Enable DHCP check box to enable DHCP (Dynamic Host Configuration Protocol) and
disable manual settings.
OR
Deselect Enable DHCP to disable DHCP and allow manual settings to be entered.
The default setting is 'Enabled'.
4 If Enable DHCP has been disabled:
a Enter the IPv4 Address in the IPv4 Address text box in the form xxx.xxx.xxx.xxx.
The default setting is '192.168.1.168'.
b Enter the Network Mask in the Network Mask text box xxx.xxx.xxx.xxx.
The default setting is '255.255.255.0'.
c Enter the Gateway IP address in Gateway text box xxx.xxx.xxx.xxx.
d Enter the Primary DNS Server in the Primary DNS Server text box xxx.xxx.xxx.xxx.
5 Select Apply to save the settings.
IPv6
Enable or disable IPv6 on the camera.
Procedure 8-2 Enable/Disable IPv6
Step Action
1 Select Setup on the GUI banner to display the setup menus.
2 Select TCP/IP from the Network menu.
3 Select the IPv6 Enable check box to enable IPv6 on the camera.
OR
Deselect the IPv6 Enable check box to disable IPv6 on the camera.
The default setting is 'Enabled'.
If IPv6 is enabled, the Link Local and DHCP address will be displayed beside 'Current IPv6 Addresses',
if available.
95
- End -
- End -