Illustra Pro PTZ 30x Configuration User Manual page 48

Scans
You will be prompted to confirm the deletion.
Note:
You cannot delete a pattern while it is associated with another camera function. To remove the pattern,
refer to the associated camera function.
4 Select OK to confirm the deletion.
OR
Select Cancel.
Repeating a Pattern
Use this procedure to have a pattern repeat until interrupted by a camera command.
Procedure 4-15 Enable/Disable Repeat a Pattern
Step Action
1 Select Setup on the GUI banner to display the setup menus.
2 Select Patterns from the PTZ menu.
3 Select the Repeat tab.
The Repeat tab displays.
4 Select the Repeat Pattern check box to allow the selected pattern to repeat continuously.
OR
Deselect the Repeat Pattern check box to allow the selected pattern to run only once.
The default setting is 'Enabled'.
Scans
A scan allows you to program left and right scan limits to automate surveillance activities. Once these scan limits
are programmed, you can choose to run a smooth scan, stepped scan, or random scan. When active, the scan
repeats until interrupted by a camera command, preset, pattern or alarm.
Setting Scan Limits
Set left and right scan limits on the camera.
Procedure 4-16 Set Scan Limits
Step Action
1 Select Setup on the GUI banner to display the setup menus.
48
- End -
- End -