Illustra Pro PTZ 30x Configuration User Manual page 118

Record Settings
• Unmount the microSD Card for Removal - Use this procedure when you are unable to access the
power supply to the camera.
Note:
Refer to the Quick Reference Guide supplied with the product for details on how to remove the housing
assembly and gain access to the camera.
Procedure 10-3 Remove the microSD Card by Powering down the Camera
1 Turn off the camera by disconnecting the power supply.
2 Remove the microSD card from the camera.
Note:
AVI clips will not be available on the camera until the microSD card has been inserted and the camera
rebooted.
3 Reconnect the power supply and power up the camera.
When the camera is restarted, it checks its functionality by performing a homing routine during which the
camera pans and then either goes to the start point of the 'apple peel' pattern or if powered up once
before, to the last position in memory. Once the camera stops, it is online and ready to be accessed and
controlled.
Procedure 10-4 Unmount the microSD Card for Removal
Step Action
1 Select Setup on the GUI banner to display the setup menus.
2 Select SD Card Management menu from the Edge Recording menu.
3 Select Unmount.
You will be prompted to confirm the unmounting.
4 Select OK to confirm.
OR
5 Select Cancel.
Remove the microSD card from the camera.
AVI clips will not be available on the camera until the microSD card has been inserted and mounted.
Record Settings
Select which video stream to use for alarm video and configure pre and post event durations for the playable video
clip. The camera can record video generated from MD, face detection and DIO events.
Illustra Pro PTZ Configuration & User Guide
- End -
- End -
118