Illustra Pro PTZ 30x Configuration User Manual page 134

Resetting the Camera to Factory Default Settings Using the Reboot/Reset Switch
Resetting the Camera to Factory Default Settings Using the
Reboot/Reset Switch
The reset/reboot switch can be used to restore the camera to the factory default settings.
Note:
It is not possible to retain network settings, presets, patterns or sequences when using this procedure. If you need
to maintain these settings it is recommended to reset the camera using the GUI. Refer to
on Page 104.
Procedure 1-2 Reset the Camera to Factory Default Settings Using the Reboot/Reset
Switch
Step Action
1 Locate the reset/reboot switch on the camera.
Refer to Figure 1-1 Reset/Reboot Switch on the Camera.
2 Press and hold the reset/reboot switch for at least 10 seconds.
3 Release the reset switch.
It may take up to 10 seconds for camera to restart.
When the camera is restarted, it checks its functionality by performing a homing routine. During this
routine, the camera pans and then either goes to the start point of the 'apple peel' pattern or if powered up
once before, to the last position in memory. Once the camera stops, it is online and ready to be accessed
and controlled.
134
- End -
Resetting the Camera