Illustra Pro PTZ 30x Configuration User Manual page 55

Areas
Areas
Areas allow sections within the field of view to be labeled. These labels may then be turned on within the Overlay
Settings option. Areas may not overlap. The zoom level affects the size areas may appear.
You may program up to 16 areas on the camera.
Programming an Area
Set an area on the camera.
Procedure 4-25 Program an Area
Step Action
1 Select Setup on the GUI banner to display the setup menus.
2 Select Areas from the PTZ menu.
The Areas tab displays.
3 Select
The video pane will display the current camera view.
4 In a numbered slot on the areas table, select
5 Enter the area name in the Name text box
6 Adjust the camera view as required to locate the left boundary.
Refer to
7 Select Set in the Left column to set the displayed position as the left boundary.
Note:
This must not be less than the right boundary of the previous area.
8 Adjust the camera view as required to locate the right boundary.
9 Select Set in the Right column to set the displayed position as the right boundary.
Note:
This must not be greater than the next area's left boundary.
10 Select Add to save the area.
OR
Select Cancel.
Illustra Pro PTZ Configuration & User Guide
to start the video stream if it is not already active.
Using the Camera Controls
to add the new area.
on Page 5 to make the necessary adjustments.
- End -
55