Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Illustra Essentials IES01CFACWSY
Summary of Contents for Illustra Essentials IES01CFACWSY
-
Page 1: User Manual
Illustra Essentials Indoor HD Mini Dome User Manual 8200-1102-06 B0... - Page 2 Notice Please read this manual thoroughly and save it for future use before attempting to connect or operate this unit. The information in this manual was current when published. The manufacturer reserves the right to revise and improve its products. All specifications are therefore subject to change without notice. Copyright Under copyright laws, the contents of this manual may not be copied, photocopied, reproduced, translated or reduced to any electronic medium or machine-readable form, in whole or in part, without...
-
Page 3: Important Safeguards And Warnings
Important Safeguards and Warnings 1．Electrical safety All installation and operation should conform to your local electrical safety codes. The power shall conform to the requirement in the SELV (Safety Extra Low Voltage) and the Limited power source is rated 12V DC or 24V AC in the IEC60950-1. (Refer to general introduction) Please note: Do not connect two power supplying sources to the device at the same time;... - Page 4 6. Daily Maintenance Please shut down the device and then unplug the power cable before you begin daily maintenance work. Do not touch the CCD (CMOS) optic component. You can use the blower to clean the dust on the lens surface.
-
Page 5: Table Of Contents
Table of Contents Important Safeguards and Warnings ......................iii Table of Contents ............................v General Introduction ............................1 Overview ................................ 1 Features ................................. 1 Specifications ..............................2 Performance ..............................2 Framework ................................ 5 Structure ................................. 5 Dimensions ..............................6 Device Installation ............................8 Quick Configuration Tool.......................... -
Page 6: General Introduction
General Introduction Overview This series network camera integrates the traditional camera and network video technology. It adopts audio and video data collection, transmission together. It can connect to the network directly without any auxiliary device. This series network camera uses standard H.264 video compression technology and MJPEG audio compression technology, which maximally guarantee the audio and video quality. -
Page 7: Specifications
Specifications Performance Please refer to the following sheet for network camera performance specification. Model IES01CFACWSY Parameter Main Processor High performance DSP Embedded LINUX System Support real-time network, local record, and remote operation at the same Resources time. User Interface Remote operation interface such as WEB, DSS, PSS System Status SD card status, bit stream statistics, log, and software version. - Page 8 396 (18*22) detection zones; sensitivity level ranges from 0 to 100; area threshold ranges from 0 to 100. Motion Detect Activation event: video storage, image snapshot, log, email function and etc. Activation event: video storage, image snapshot, log, email function and Video Loss etc.
- Page 9 Standard PAL: Main stream (1920*1080@25fps) Extra stream (704*576@25fps) NTSC: Video Frame Rate Main stream (1920*1080@30fps) Extra stream (704*480@30fps) H.264H: 16Kbps-8192Kbps, adjustable Video Bit Rate MJPEG adjustable and bit rate is adjustable. Support customized setup. Support mirror function. Video Flip Support flip function. Snapshot Max 1f/s snapshot.
-
Page 10: Framework
Framework Structure Please refer to the following figure for detailed information. See Figure 2-1. Note Figures in this chapter are for reference only.. Please use figure according to the actual product. Figure 2-1 Structure Please refer to the following sheet for detailed structure information. Name X-Y-Z rotation module Device lens... -
Page 11: Dimensions
Network data input, output and PoE. Note: Network port Some devices do not support PoE. Before making crystal head, pull the anti-dust, waterproof cover through network cable. MIC hole Audio input Dimensions Please refer to the following figure for the dimension information. The unit is mm. See Figure 2-2 through Figure 2-4. - Page 12 Figure 2-4 Dimension illustration 3...
-
Page 13: Device Installation
Device Installation Note Before the installation, please make sure the installation environments can at least support 3x weight of the camera. Please follow the steps listed below to install the device. Figure 3-1 Device installation illustration 1 Figure 3-2 Device installation illustration 2 Step1 Use the inner hexagonal wrench (provided) to loose the three inner hexagon screws in the dome cover and then open the cover. - Page 14 Step 3 Draw and then dig three plastic expansion bolts holes on ceiling or other installation surface and then insert three expansion bolts in the holes. Secure these three bolts firmly. Note: Please make a “cable exit hole” in the surface according to the installation map if you want to draw out the cable from the top of the installation surface.
-
Page 15: Quick Configuration Tool
Quick Configuration Tool Overview Quick configuration tool can search current IP address, modify IP address. At the same time, you can use it to upgrade the device. Please note the tool only applies to the IP addresses in the same segment. Operation Double click the “ConfigTools.exe”... - Page 16 If you want to modify the device IP address without logging in the device web interface, you can go to the configuration tool main interface to set. In the configuration tool search interface (Figure 4-1), please select a device IP address and then double click it to open the login interface.
-
Page 17: Web Operation
Web Operation This series network camera products support the Web access and management via PC. Web includes several modules: Monitor channel preview, system configuration, alarm and etc. Network Connection Please follow the steps listed below for network connection. • Make sure the network camera has connected to the network properly. •... - Page 18 Figure 5- 2 Web login After you successfully logged in, please install WEB plug-in unit. Please refer to the Web Operation Manual included in the resource CD for detailed operation instruction. See Figure 5- 3. Figure 5- 3 Web monitoring window...
-
Page 19: Faq
I can not boot up Please click RESET button for at least five seconds to restore factory the device. default setup. I can not upgrade When network upgrade operation failed, you can use port 3800 to the device via continue upgrade. network. -
Page 20: Appendix Toxic Or Hazardous Materials Or Elements
Appendix Toxic or Hazardous Materials or Elements Toxic or Hazardous Materials or Elements Component Name Cr VI PBDE Circuit Board ○ ○ ○ ○ ○ ○ Component Device ○ ○ ○ ○ ○ ○ Construction Material ○ ○ ○ ○ ○...