Illustra Pro PTZ 30x Configuration User Manual page 77

Procedure 6-1 Install exacqVision Edge Server using Purcahsed SD Card with
exacqVision Server
Step Action
1 Insert the SD card before powering up your camera.
2 The edge server will automatically be installed when the camera starts for the first time.
3 Select Setup then Applications to confirm the exacqVision Edge Version.
Procedure 6-2 Install exacqVision Edge Server using the Camera GUI
Step Action
1 Insert a blank SD card into the camera.
2 Select Setup then Applications.
3 Select Browse and navigate to the selected file required for the upload.
4 Select Upload this will install the edge server on the PC.
Note:
You will have to select Start under the Stop/Start tab to run the edge server even if the edge server has been
installed.
How to use the Edge Server
When selected via Setup and Applications the exacq server will be listed as seen in Figure 1-1. Both the
Installed and Running state will be listed as Yes.
Note:
When the SD card is not detected for example when there is no SD card in the camera, it has been improperly
mounted, or a error has been found on the SD card itself, there will be an error message displayed when you click
the Start button to run the edge server. If this happens, insert the SD card or format and properly mount the card
on the camera.
The edge server can be started by selecting Start and stopped by selecting Stop.
Note:
If the camera reboots when the status of the edge server is listed as Stopped, it will be necessary to select Start
as the edge server cannot automatically run unless manually started.
77
- End -
- End -