Table of Contents
Advertisement
Maintenance
Maintenance
The Maintenance menu allows you to restore the camera settings to factory default, reboot the camera and apply
a firmware upgrade.
Reset
To perform a physical reset of the camera, refer to
Reboot/Reset Switch
Note:
Network settings, presets, patterns and sequences can be retained if required.
Procedure 9-1 Resetting the Camera
Step Action
1
Select Setup on the GUI banner to display the setup menus.
2
Select Maintenance from the System menu.
3
Select the Maintenance tab.
4
Select the Preserve IP address check box to retain the current network settings during the camera
reset.
OR
Deselect the Preserve IP address check box to restore the default networking settings.
The default setting is 'Enabled'.
5
Select the Preserve applications check box to retain the current applications installed on the camera
during the camera reset.
OR
Deselect the Preserve applications check box to remove existing applications.
The default setting is 'Enabled'.
6
Select the Preserve presets, patterns and sequences check box to retain the current presets, patterns
and sequences during the camera reset.
OR
Deselect the Preserve presets, patterns and sequences check box to remove existing presets,
patterns and sequences.
The default setting is 'Enabled'.
7
Select Reset
You will be prompted to confirm the camera reset.
8
Select OK to confirm. The Web GUI will display a "Camera Resetting" page with a progress bar showing
the reset progress.
When the camera is restarted it will take 2 - 3 minutes until it is online and ready to be accessed and
controlled.
OR
104
on
Page
134.
Resetting the Camera to Factory Default Settings Using the
Hide quick links:
Advertisement
Table of Contents
