Table of Contents
Advertisement
Audio
4
Select the Output Enable check box to enable the audio output settings.
Or
Deselect the Output Enable check box to disable audio input settings.
The default setting is 'Disabled'.
5
If Output Enable has been enabled, use the slider bar to select the Output Volume.
Values range from 1 to 100.
The default setting is 50.
Configuring Stored Audio
When connected to an appropriate device, the camera is capable of playing back stored audio when an alarm has
been triggered. A maximum of five audio files can be uploaded to the camera.
Note:
Audio clips can only be used if a microSD Card has been installed. Refer to the relevant Quick Reference Guide
for information on installing the microSD Card.
Refer to
Upload an Audio File
uploaded.
Procedure 9-9 Play Stored Audio
Step Action
1
Select Setup on the GUI banner to display the setup menus.
2
Select Audio from the System menu.
3
Select the Audio Clips tab.
4
Select to play back the corresponding audio file.
Procedure 9-10 Upload an Audio File
Step Action
1
Select Setup on the GUI banner to display the setup menus.
2
Select Audio from the System menu.
3
Select the Audio Clips tab.
4
Select Upload next to the corresponding audio file.
The Choose file dialog will be displayed.
5
Navigate to the location where the audio file has been saved.
Select the audio file and then select the Open button.
Illustra Pro PTZ Configuration & User Guide
- End -
on
Page 109
for the requirements that must be met by an audio file that is being
- End -
109
Hide quick links:
Advertisement
Table of Contents
