Illustra Pro PTZ 30x Configuration User Manual page 50

Scans
The video pane will display the current camera view.
(Before activating a scan, refer to
4 Select
• Smooth - slowly pans between the left and right scan limits, starting at the left scan limit.
When the right scan limit is reached, the scan reverses
• Stepped - pans slowly, pausing briefly every 10° between the left and right scan limits. Once
the right scan limit is reached, the scan reverses.
• Random - pans randomly between the left and right scan limits. For example, the scan may
start at 10°, then pan right 40° and pause, pan right 20° and pause, pan left 30° and pause, and
pan right until it reaches the right scan limit.
5 The video pane will update to display the selected scan.
6 The scan will run continuously until interrupted by a camera command, pattern, preset or alarm.
Motion Tracking
The Motion Tracking feature enables the camera to detect motion in the field of view and once detected track the
motion using the PTZ functionality of the camera. The Duration setting allows the configuration of the time an
object is tracked once it is detected.
Note:
Any changes to the Motion Tracking configuration applies to both Scans and Sequences.
Motion Tracking together with Stepped Scans or Sequences can be used to complete Intelligent Guard Tours.
For more information on Intelligent Guard Tours refer to
Motion Tracking can be used with or without Motion Detection enabled.
Note:
It is recommended that Motion Detection is enabled with Intelligent Guard Tour to allow the camera to raise a
Motion Detection Alert to the Network Video Recorder allowing recording of the object being tracked.
To enable Motion Detection refer to
If Motion Detection is enabled and motion tracking is disabled:
• When a motion start alarm is sent and the camera initiates a PTZ movement, whether manual or by
a Program (e.g. Preset, Pattern, Sequence or Scan), a stop alarm will be forced to "close" the alarm.
If motion detection is enabled, motion tracking is enabled, and a Sequence or Scan started:
• When there is motion, a motion start alarm is sent, motion tracking starts (camera starts using PTZ
functionality to follow the motion). Only when there are 3 seconds of no motion, or the motion
tracking duration expires, is there a motion stop alarm sent. The camera will then resume to the next
set point of the Sequence or Scan.
If motion detection is disabled, motion tracking is enabled, and a Sequence or Scan started:
50
Set Scan Limits to Default Settings
to activate the corresponding scan.
Enable or Disable a Motion Detection Alert
- End -
Appendix A- Intelligent Guard Tour
on Page 49.)
on Page 131.
on Page 68