Configuring The Pppoe Server; Configuring A Pppoe Session - HPE FlexNetwork MSR series Configuration Manual

Figure 10 Network structure 1
Carrier device
Client device
•
As shown in
the carrier router (PPPoE server). The service provider assigns an account to each host for
billing and control. The host must be installed with PPPoE client software.
Figure 11 Network structure 2
PPPoE Client
Host A
PPPoE Client
Host B

Configuring the PPPoE server

Configuring a PPPoE session

Step
1. Enter system view.
2. Create a VT interface and
enter VT interface view.
3. Set PPP parameters.
4. Enable MRU verification.
DSLAM
Router A
Host A Host B
Figure 11, a PPPoE session is established between each host (PPPoE client) and
PPPoE Server
Router
Command
system-view
interface
number
See
ppp
PPPoE server
Router B
Modem
PPPoE client
Host C
Internet
virtual-template
"Configuring PPP."
lcp echo mru
45
Internet
Remarks
N/A
N/A
If authentication is needed, use
the PPPoE
authenticator.
verify By default, MRU verification is
server as the